How To install Trex Decking?

/
/
/
613 Views

Do you wonder how to install Trex decking and think that you will not do it by yourself? Then, you have two choices, following the installation steps or just finding a reliable company that will do it for you.

Over the past 20 years, composite decking has advanced significantly, and Trex was one of the earliest innovators in the field. By creating the most significant advancement in composite technology—the Trex high-performance, weather-resistant shell—Trex advanced the composite industry as well.

How To install Trex Decking

After buying a Trex for a house, many people start questioning how to install Trex decking. Depending on how the fascia is going to be put, the first deck board on a deck build should be placed on the front rim of the deck. Use a spare piece of wood to support it 1’’ above the deck’s rim joist. Fasten the stop block to the rim joist every two to three feet and then attach the boards.

The deck board needs to be notched around the guardrail posts before they are placed. Transfer the posts’ line to the deck board using a speed square. Keep the speed straight away from the post’s side. Use a speed square to mark the post on both sides.

After that, mark the deck board to be cut at the post’s center measurement, then cut the measurements. Place the deck board on the deck frame once all notches have been cut out.

Set the deck board in place with a clamp so that it is flush with the rim joist’s exterior edge. Push firmly on the deck board and rim joist with the clamp. tighten the clamp, then switch to the next clamp until it is finished.

How Do You Fasten Trex Decking?

You can use a deck fastening system called the Trex Hideaway® Secret Fixing System which is made specifically for a fastener-free deck surface around the perimeter that is free of visible screws or nails.

How Do You Start Installing?

First, protect your substructure, then cut your boards and choose your layout. After that, use screws to connect two boards together and tighten as you go. Cover the decking edges and you are good to go.

Do You Screw or Nail Trex Decking?

Two screws should be used per joist, according to Trex. Every screw that is suggested is made to be fitted flush with the decking surface. Screws should not be countersunk.

How to install Trex decking is answered officially by Trex and they recommend installing posts at 6 or 8-foot intervals, but be sure you measure, then cut your baluster spacers and railings as necessary.

Leave a Comment

Your email address will not be published. Required fields are marked *

This div height required for enabling the sticky sidebar
Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views :